Entire Contents © 2013 Hobbico®, Inc. HMXE0830 RTF v2 w/o camera HMXE0832 RTF v2 with camera1Si QuadcopterInstruction Manual®Please fully read and
10HoveringOnce the quad is in the air simply try to keep it in one spot. This will take some practice. Remember that even a light breeze will have an
11If the model is to be stored for a long time period, please remove the batteries from the transmitter to avoid damage to the contacts. If storing th
12To return to the normal fl ight mode, press the “F Mode” button again. The rear LED will fl ash twice, stay on for a second, fl ash twice again, and th
13This procedure should be used if the return speed of the 1Si needs to be changed.1. Enter the Adjustment Mode as described earlier.2. Push the rudde
14on the card again and the inner spring system will help eject the card. Note: The card must be in place to capture video or Pictures. The camera has
15Control Board Sensor Calibration1. Enter the Adjustment Mode as described on page 12.2. Press up on the throttle trim button and the rear LED on the
16Hold the transmitter by the upper right corner and lower left corner so the antenna is pointed 45 degrees to the right. Rotate the transmitter three
17Solution 3: Make sure card is OK by putting the card in reader and checking on your PC.PROBLEM: 1Si drifts while hovering.Solution: Use the followi
18 ®REPLACEMENT PARTSREPLACEMENT PARTS Key Part No. Description 1 HMXE2203 Blade Guard (4) 2 HMXE2202 Rotor Blades Black / White 3 HMXE2244
19®EXPLODED VIEWEXPLODED VIEW2323465789101112131313141131
2®INTRODUCTIONINTRODUCTIONThank you for purchasing the Heli-Max 1Si Quadcopter. We are certain you will get many hours of enjoyment out of this model.
20Entire Contents © 2013 Hobbico®, Inc. HMXE0830 RTF v2 w/o camera HMXE0832 RTF v2 with camera®
3®WARRANTY SERVICEWARRANTY SERVICEHeli-Max guarantees this kit to be free from defects in both material and workmanship at the date of purchase. This
4®FEATURES & SPECIFICATIONSFEATURES & SPECIFICATIONSFeatures● Switchable TAGS-FX™ Sensor Fusion stabilization system● On board micro digit
5away from the rotors. The spinning blades of a model of this type can cause serious injury.● When choosing a fl ying site stay clear of buildings, tr
6Charge Warnings● Only use the included charger with the included LiPo battery. Do not attempt to use the provided charger with NiCd, NiMH or batteri
7Transmitter Setup❏ Install 4 AA batteries in the transmitter by removing the battery cover from the back of the transmitter. Double-check the polarit
8 ®INSTALLING THE BLADE GUARDSINSTALLING THE BLADE GUARDSInstalling the optional rotor blade guards is recommended. Besides protecting the rotor bl
9❏ Slide the guard over the motor and position the hole for the mounting screw over the dimple on the top of the arm.❏ Secure the guard to the frame w
Comments to this Manuals